Tascam CD-RW402 - Manual (Page 22)

4 – Playback operations—Simple playback operations
22
TASCAM CD-RW402 Owner’s Manual
Track skip
Use the MULTI DIAL (or the track skip keys on the
remote control unit) to jump forward or backward by
one track at a time, as shown on the display.
Note that going forward from the last track of the
disc will “wrap round” to track 1, and going back-
ward from the first track of the disc will “wrap
round” to the last track of the disc.
The track number indicators at the bottom of the dis-
play shows the selected track (the lit indicator at the
left of the row of indicators).
It is also possible to use the number keys on the
remote control unit to jump directly to a particular
track:
1 Select drive 1 or 2 with the switch as appro-
priate.
To play tracks 1 through 9, simply press the
appropriate key (
1 through 9 ).
2 To play a track whose number is higher than
9, press the
+10 key an appropriate number
of times to set the “tens” digit of the track
number, followed by a single key to set the
“units” digit. For example:
Track 13 = +10 , 3
Track 30 = +10 , +10 , +10 , 0
NOTE
On the main unit only, the search keys can be used to
“fast-forward” and “fast-rewind” through the disc.
Cue point
The cue point is the point at which playback last
started from ready mode. Every time the unit goes
from ready mode to play mode, the cue point is
updated.
To return to the cue point, from stop, ready or play
mode:
1 Simply press the CALL key. The playback
position is returned to the cue point and the
drive enters ready mode. Press
PLAY to start
playback from this point.
NOTE
This call function is not available in the shuffle playback
mode.
A and B points (drive 1 only)
The A and B location points provide two more con-
venient memory locations and they may also be used
when copying discs.
To set these points:
1 Press the MEMO IN key so that the indicator
is lit.
2 At the playback point to be assigned, press
either the
LOC A or the LOC B key.
If a point has already been assigned to these
locations, the indicator will be lit. If no point
has been assigned to these locations, the indi-
cator lights when the point is assigned.
The MEMO IN indicator goes out.
3 Repeat the process for the other location
point, if desired.
Using the location points
To use these location points as points for playback,
simply press the appropriate
LOC A or LOC B key
(when the indicator is lit). The playback position
moves to the location point and the drive enters ready
mode.
Erasing the location points
The location points are automatically erased (the
point is unassigned from the location point) when the
drive tray is opened, or they can be erased in stop
mode by pressing
MEMO IN followed by the LOC A
or LOC B key (the indicator goes out).
NOTE
The A and B points should not be too close together
(that is, less than four seconds) when being used for
copying as described in “Copying discs” on page 44.