Toshiba PCS-1 - Manual (Page 25)

PCS-1/1P
3-207-456-12 (1)
I:\3207456121PCS1WW\03OVR.FM masterpage:Left
25
Turning the System On/Off
C
h
apt
er
1:
In
st
al
la
tio
n
an
d Pr
e
p
a
ra
tio
n
You can turn on the Video Communication System with the @ / 1 button on the
Remote Commander if it is in standby mode.
1
Display the launcher menu on the monitor screen, then press the @ / 1 button
on the Remote Commander.
The message “Power off?” appears on the monitor screen.
2
Press the B or b button on the Remote Commander to select OK, and press
the PUSH ENTER button.
You may press the @/1 button on the Remote Commander.
The Video Communication System enters standby mode and the POWER
indicator on the Communication Terminal lights in orange. The POWER
indicator on the camera goes out.
If the IR repeater is installed in a Sony TV monitor, it will go into standby
together with the Video Communication System.
When the Communication Terminal and the Camera are separately installed, point the
Remote Commander to the Camera for operations.
To cancel setting the system to standby
Select “Cancel” with the B or b button on the Remote Commander, then press
the PUSH ENTER button in step 2 above.
Setting the Video Communication System to Standby Mode
Note
POWER indicator (Not lit.)
POWER indicator (Lights in orange.)
@ / 1 button
B / b buttons and PUSH ENTER
button