Toshiba PCS-1 - Manual (Page 38)

38
Registering Local Information
PCS -1/1P
3-207-456-12 (1)
I:\3207456121PCS1WW\04SET.FM masterpage:Left
56K: Selects when connecting a remote
party in a region or country where the
ISDN transmission rate is 56 Kbps.
The system is set to connect an ISDN line at the
transmission rate of 64 Kbps at the factory.
However, some countries such as the USA or
some regions may use the ISDN transmission
rate of 64 Kbps and 56 Kbps. You may not
communicate with such country or region with
the transmission rate of 64 Kbps. In this case,
set “Restrict” to “56K” before dialing.
Page 2/4
Video Mode
Selects the compression format of the
pictures to be sent to a remote party.
ALL: Sends pictures of any compression
format depending on the format used on
the remote site.
MPEG4: Sends pictures based on the
MPEG4 format.
H.263+: Sends pictures based on
Recommendation H.263+.
H.261: Sends pictures based on
Recommendation H.261 (when sending
still images using Annex D).
Video Frame
Selects the number of video frame for
transmission.
15fps: Sends CIF format pictures at a
maximum rate of 15 frames per second.
30fps: Sends CIF format pictures at a
maximum rate of 30 frames per second.
Audio Mode
Selects the compression format of audio to
be sent to a remote party.
ALL: Sends any audio compression format
depending on the format used on the
remote site.
MPEG4 Audio: Sends audio based on the
MPEG4 format.
G.722.1: Sends audio based on the G.722.1
standard.
G.722: Sends audio based on the G.722
standard.
G.729: Sends audio based on the G.729
standard.
G.728: Sends audio based on the G.728
standard.
G.723.1: Sends audio based on the G.723.1
standard.
G.711: Sends audio based on the G.711
standard.
When the remote videoconferencing system
does not support the Audio Mode selected by
the local site, the mode automatically switches
to “G.711”.
Far End Camera Control
When the conference starts by calling a
remote party from the local site, selects
whether to enable control of each other’s
cameras from each other sites.
On: Enables control of each other’s
cameras. Normally, set to ON.
Off: Disables control of each other’s
cameras.
T.120 Data
Selects whether you conduct a data
conference via the T.120 standard using
NetMeeting.
On: Enables conduct of the T.120 data
conference.
Off: Disables conduct of the T.120 data
conference.
For details on the T.120 data conference,
see “Conducting a Data Conference Using
NetMeeting – T.120 Data Conference” on
page 112.
Note
Page: 2/4
ALL
Dial Setup
Video Mode
15fps Video Frame
ALL Audio Mode
On Far End Camera Control
On T.120 Data
Save Cancel
Note