Toshiba 32SL415U - Manual (Page 26)

Chapter 4: Initial Setup and Menu
26
6無
Start Scan
Start Scan
Auto Tuning
Press .
Note: If you want to stop scanning, press
while scanning.
• After scanning is complete, a channel list screen
(such as the one below) will appear. Press or
.
Note: Encrypted channels cannot be registered
though these are displayed in the above list.
If some channels are not found after scanning:
• Check the antenna/cable connections, and scan
again.
• Connect the TV to the antenna or cable box directly
and scan again.
1無 > Settings > SETUP > Quick Setup > .
2無 A confirmation message appears. Press t or u
to select
Yes. Press .
3無 Repeat set up to Step 6.
• If you selected Antenna previously, select
Cable.
• If you selected Cable previously, select
Antenna.
4無 Scan again.
7無
Support Information
The Support Information screen appears. Press .
Note:
Refer to this information if there is any
problem and you need to contact Customer
Support. This can be confirmed from the
following operation at any time.
> Settings > SETUP > System Information >
.
Navigating the menu system
• To open the main menu, press on the remote
control or TV control panel.
• Press p, q, t, or u on the remote control or TV
control panel to navigate and make selections.
• To select a menu option, press .
• To move to the next menu layer, press or p.
• To return to the previous menu layer, press or q.
• To close a menu instantly, press or .
• All menus will close automatically if you do not make
a selection within 60 seconds.