Toshiba 32SL415U - Manual (Page 79)

79
Chapter 10: Appendix
Operating other devices
Your TV remote control has one dedicated TV mode
and three programmable multi-brand modes:
CABLE/
SAT, BD/DVD, and AUX.
Note:
To operate a non-Toshiba device or a Toshiba
device that the remote control is not preprogrammed
to operate, you must program the remote.
Mode select Default device mode control
(before programming)
TV Toshiba TV
CABLE/SAT Toshiba Satellite receiver
BD/DVD
Toshiba Blu-ray Disc ™ player
AUX Onkyo Receiver
Mode select Device mode control
(after programming)
TV Toshiba TV
CABLE/SAT
Multi-brand video/audio devices BD/DVD
AUX
Note: If you cannot program the TV’s remote to operate
your device or some of its features, use the device’s
remote or the controls on the device.
Programming the remote to
operate other devices
Device code setup
1無
Find the code for your device brand in the remote
control device code table (
 page 82–87).
If multiple codes are listed, try each one
separately until you find one that works.
2無
Press a mode select button ( CABLE/SAT, BD/DVD,
or AUX).
3無
While holding down , input the 4-digit code
for your device.
4無
Point the remote at the device. Press to test the
code.
Result Meaning
The device responds. Valid code
The device does not
respond.
Invalid code
Repeat the procedure, using
another code
5無
When programming is complete, test all necessary
keys on the TV’s remote that operate your device.
If some keys are not operational, repeat the device
code setup using another code (if other codes are
listed for your device).
6無
To control the TV, press TV.
7無
If your VCR does not respond to the codes for
your VCR brand, and has a switch labeled VCR1/
VCR2, set the switch to the other position, then
program the remote control.
Note: Every time you change the batteries, you must
reprogram the remote.