Player menus, Speaker menu, Progressive scan – Technicolor - Thomson DPL953REC User Manual
Page 25: Front / [l/r]-[cen] / rear distance, Speaker test
Player Menus
25
EN
Progressive Scan
Progressive Scan provides high-quality pictures with less
flicker.Turn on Progressive Scan if you used the
Component Video sockets of the player to connect a TV
or monitor compatible with a progressive scan signal.
1.
Press or
ENTER
to access the sub-menu.
2.
Select ON using the
and
buttons to activate
Progressive Scan.A confirmation screen appears.
3.
Select OK using and
press
ENTER
.
Note: If you finally do not wish to activate Progressive Scan,
select Cancel and press
ENTER
.
Caution! Once Progressive Scan has been activated, an image
will only be visible on a progressive scan TV or monitor.
If you activate Progressive Scan by mistake, you should take
the following steps to reset the unit: open the disc tray, press
and hold the
MENU/PBC
button and the number button 7.
The video output will be restored to the standard setting and
a picture will once again be visible on a conventional analogue
TV or monitor.
Speaker menu
1.
Press the
SETUP
button to display the player’s menu.
2.
Select Speaker using the
and
buttons.
3.
Press or
ENTER
to access the sub-menu.
Front / [L/R]-[CEN] / Rear Distance
To make the surround sound more effective and suit the
acoustic conditions in the room where you are listening,
you may need to delay the signal coming from some of
the speakers.
1.
Select Front Distance or [L/R]-[CEN] Dist. or
Rear Distance using the
and
buttons and
press or
ENTER
to access the sub-menu.
2.
Adjust the distance using the
and
buttons and
press
.
Speaker Test
This function is used to test the speaker setting and
change the speaker level.
1.
Press or
ENTER
to access the sub-menu.
2.
Press or
ENTER
again and select ON using the
and
buttons to start the speaker test.A short
noise comes successively from each speaker.
3.
Press
to stop the test.
Menu
ENABLE PROGRESSIVE
1. Ensure your TV has progressive scan
2. Ensure connect Y Pb Pr cable to TV.
3. If TV display is abnormal,
wait 8 seconds for recover.
Cancel
Press SETUP to exit. Current selection
Recorder
S
L
V
S
A
TV Tuner
TV Type OFF
Menu
Front Distance
[
L/R
]
-
[
CEN
] DIST
Rear Distance
Speaker Test
Press SETUP to exit.
Recoder
System
Language
Video
Speaker
Audio
TV Tuner
Speaker Setup
Speaker Test ON
OFF
Press SETUP to exit. Current selection
DPL953REC_EN 17/11/05 8:59 Page 25