Tascam DP-02 - Manual (Page 33)

IMPORTANT SAFETY INSTRUCTIONS
TASCAM DP-02/DP-02CF

2 – Advanced techniques
When you have rehearsed your punch-in, you can start
recording.
1. Press the RHSL key so that the indicator goes out
(but the AUTO PUNCH indicator is still lit).
2. Press PLAY ( ¥ ) so that playback starts. Use the
pre-roll time to get ready to record.
At the punch-in point, the unit goes into record mode (the
RECORD ( – ) indicator lights).
At the punch-out point, recording stops (the RECORD ( – )
indicator goes out), and playback continues until the post-
roll point and then returns to the pre-roll point. The
AUTO
PUNCH indicator is turned off (the track arming status
stays the same).
If you want to re-record the punch, turn AUTO PUNCH
back on before recording again.
Punch recording
The pre-roll and post-roll times can be set to suit your style
of playing.
1. Press MENU and scroll down to PREFERENCE and
press the ¥ cursor or YES/ENTER key.
NOTE
The N.SUPPRESSOR setting os only available on the
DP-02. The DP-02CF will not show this option.
2. Use the cursor keys to move the cursor to the Pre
(pre-roll time) item, and use the DATA dial to set the
value in seconds.
T I P
The pre-roll and post-roll times can be set between 1.0
seconds and 9.9 seconds in 0.1 second steps.
3. Use the cursor keys to move down to the Post (post-
roll time) item and use the DATA dial to change the
value.
4. Press NO/EXIT when you’re done, so that you can
start using these settings.
Pre-roll and post-roll time