Toshiba D-R160SB - Manual (Page 29)

Recording
Playback
Editing
Introduction
Connections
Basic Setup
Function Setup
Others
Basic Setup
29 EN
Channel setting
Auto tuning
Manual tuning
Tuning of this unit to broadcast channels can be performed in two ways.
Programme the tuner to scan only the channels you can
receive in your area.
1) In stop mode, press [SETUP].
Setup menu will appear.
2) Select “Channel” using [K / L], then press
[ENTER].
Channel menu will appear.
3) Select “Auto Tuning” using [K / L], then press
[ENTER].
The unit will start storing channels available in your
area.
Wait for several minutes to finish channel storing.
4) Press [SETUP] to exit.
You can select only the channels memorised in this
unit by using [PROG. / ].
Setup
Playback
Display
Recording
Clock
Channel
Disc
Required Setting
Setup
Playback
Display
Recording
Clock
Channel
Disc
Required Setting
Channel
Manual Tuning
Auto Tuning
Move
■ To select a channel
You can select a channel using [PROG.
/ ], or directly
enter the channel using [the Number buttons] on the remote
control.
■ To cancel auto tuning
Press [RETURN] or [SETUP] during scanning.
Notes
• The selection will be affected by how you receive TV
channels in your local area.
• If the auto tuning is cancelled during scanning, some
channels not yet tuned may not be received.
• Sorting of TV channels from P01 to P06 will be performed
automatically as follows.
P01: BBC1 P02: BBC2 P03: ITV
P04: CH4 P05: CH5 P06: SKY NEWS
* If you are using a satellite receiver, turn it on and select
SKY NEWS before commencing tuning.
Manually tune each channel.
1) In stop mode, press [SETUP].
2) Select “Channel” using [K / L], then press
[ENTER].
3) Select “Manual Tuning” using [K / L], then
press [ENTER].
4) Select “Position” using [K / L], then press [B].
5) Select the position number you want using
[K / L], then press [s].
You can select position numbers 01 to 99.
6) Select “Channel” using [K / L], then press [B].
Manual Tuning
Position
Channel
Decoder
Skip
P01
1
OFF
ON