Connections, 19 en 19 en, Connecting to a tv with an hdmi – Toshiba DR420KU User Manual

Page 19: Compatible port, Hdmi video resolution and actual output signals

Advertising
background image

19

EN

19

EN

Disc

Management

Recording

Playback

Introduction

Connections

Basic Setup

Editing

Function Setup

Others

CONNECTIONS

Connecting to a TV with an HDMI

TM

Compatible Port

HDMI OUT

HDMI IN

rear of this unit

Do not tilt the connector when inserting it into the HDMI jack, and make sure the
shapes of the jack and the connector are matched.

IN

OUT

Y

PR/CR

PB/CB

L

R

L

R

VIDEO

IN

VIDEO

OUT

S-VIDEO

AUDIO IN

(L1)

S-VIDEO

AUDIO OUT

COMPONENT

VIDEO OUT

COAXIAL

DIGITAL AUDIO OUTPUT

PCM / BITSTREAM

HDMI OUT

HDMI cable

HDMI Video Resolution and Actual Output Signals

Press [HDMI] to select the HDMI video resolution. The video resolution changes as follows every time [HDMI] is
pressed.

Front Panel Display

Video Output Signal

480 Progressive

Press [HDMI]

720 Progressive

Press [HDMI]

1080 interlaced

Press [HDMI]

1080 Progressive

Press [HDMI]

• The HDMI mode that is not supported by display device will be skipped.

Copyright protection system
To play back the digital video images of a DVD via an HDMI connection, it is necessary that both the player and the
display device (or an AV amplifier) support a copyright protection system called HDCP (high-bandwidth digital
content protection system). HDCP is copy protection technology that comprises data encryption and authentication
of the connected AV device. This unit supports HDCP. Please read the operating instructions of your display device
(or AV amplifier) for more information.

Note for HDMI Connection

• Because HDMI is an evolving technology, it is possible that some devices with an HDMI input may not operate

properly with this unit.

• When using an HDCP-incompatible display device, the image will not be viewed properly.

• Among the devices that support HDMI, some devices can control other devices via the HDMI connector; this unit

can be controlled by another device via the HDMI connector.

• When this unit’s HDMI connector is connected to a DVI-D compatible monitor (HDCP compatible) with an HDMI-DVI

converter cable, the signals are output in digital RGB.

• When the power failure occurs, or when you unplug the unit, some problems in the HDMI setting might occur.

Please check and set the HDMI setting again.

No supplied cables are used in this connection:

Please purchase the necessary cables at your local store.

E7PCAUD_DR420KU_EN.indd 19

E7PCAUD_DR420KU_EN.indd 19

2/6/2009 10:55:26 AM

2/6/2009 10:55:26 AM

Advertising