Toshiba DR420KU - Manual (Page 23)

23 EN 23 EN
Disc
Management
Recording
Playback
Introduction
Connections
Basic Setup
Editing
Function Setup
Others
Supplied cables used in this connection are as follows:
• RCA audio cable (L/R) x 1
CONNECTIONS
2 Channel Analog Audio Connection
IN
Y
PR/CR
PB/CB
L
R
S-VIDEO AUDIO OUT
HDMI OUT
COMPONENT VIDEO OUT
COAXIAL
DIGITAL AUDIO OUTPUT PCM / BITSTREAM
OUT
S-VIDEO
L
R
AUDIO IN (L1)
VIDEO OUT VIDEO IN
stereo system
analog audio
input jacks
AUDIO OUT
RCA audio cable
AUDIO OUT
L
R
VIDEO
OUT
AUDIO OUT
L
R
AUDIO IN
L R
rear of this unit
Note
• The audio source on a disc in a Dolby Digital multi channel surround format cannot be recorded as digital sound by
an MD or DAT deck.
• By connecting this unit to a Dolby Digital decoder, you can enjoy high-quality Dolby Digital multi channel surround
sound as heard in the movie theaters.
• By connecting this unit to the DTS decoder, you can enjoy Multi-channel Surround System which reproduces the
original sound as truthfully as possible. Multi-channel Surround System is developed by the DTS, Inc.
• Playing back a DVD using incorrect settings may generate noise distortion and may also damage the speakers.
• For audio CD and MP3 files, 2 channel PCM will be output regardless of the “Dolby Digital” setting.
If the connected device is not compatible with HDMI BITSTREAM, audio will be output as PCM even if you select
“Stream” in “Dolby Digital” setting (Refer to page 85).
• The audio signals from the HDMI connector (including the sampling frequency, the number of channels and bit
length) maybe limited by the device that is connected.
• Among the monitors that support HDMI, some do not support audio output (for example, projectors). In connections
with device such as this unit, audio signals are not output from the HDMI output connector.
• If the connected equipment is not compatible with HDMI BITSTREAM, DTS sound will not be output.
E7PCAUD_DR420KU_EN.indd 23 E7PCAUD_DR420KU_EN.indd 23 2/6/2009 10:55:27 AM 2/6/2009 10:55:27 AM