Toshiba EO1-11099 - Manual (Page 171)

- 4 -
EO1-11113
TERMINAL DESIGNATION
This operation can be performed before any in-line service operation. When this operation is
skipped, no specific terminals are designated, i.e., the in-line service operations will be performed
to all the terminals.
Any time outside a sale
Mode Lock: SET, X, or Z (depending on the in-line service operations to
follow)
RTR Declaration ON Status (i.e., the IN-LINE Lamp should be illuminated)
To be operated on the Master Terminal only.
NOTE: The Terminal Designation once declared by the above operation will be canceled
by changing the position of the Mode Lock, or by RTR Declaration Cancel, or by
turning OFF and ON the power of the terminal. The designation is automatically
canceled on completion of the operation to follow or when a new designation is
operated.
Enter the Register No. of the
Terminal subject to the in-line
service operations to follow.
| Register No. | [#] [AT/TL] [#]
Repeat for other terminals if more are subject to
the in-line service operation.
ex.) To designate the following Terminal out of two terminals in
the system:
Terminal ID No. 3: Register no. 3003
Mode Lock: SET (if operated before DLLs)
The RTR Declaration must be ON (i.e., the IN-LINE Lamp must be
illuminated; if not, depress the [RTR] key to declare RTR status).
[#] 3003 [#] [AT/TL]
(Issues a receipt, printing the Register Nos of the terminals
designated in the above operation.)
P 0 0
03 #3003
0023 14:33TM
TEC STORE
1343 PEACH DRIVE
PHONE : 87-6437
Open 8:00am to 7:00pm
Closed : every Wednesday
12-19-1994 MON #1
CONDITION
OPERATION
.....