Toshiba MA-1595-1 Series - Manual (Page 139)

6. PROGRAMMING OPERATIONS EO1-11152
6.6 PLU Table Programming (Submode 4)
6-22
6.6.3 PLU Programmed Data Copying
This operation is used to copy the programmed data of a PLU item and to use it in programming another PLU
item, thus eliminating time in PLU programming operation.
To program new PLUs or to change any programmed contents of PLUs:
Any time outside a sale (except the following case)
To change the PLU of the copy-destination with sales data not zero:
After PLU Reset
4
[X] |PLU Code of the copy-destination| [PLU] [NS]
|PLU Code of the copy-source| [PLU]
The programmed data of the copy-source PLU is now copied to the copy-destination
PLU (except the PLU Code). Then follow the procedure in Section 6.6.1
Programming or Changing to change data of any required Addresses.
Example) To program PLU 90701 (Drink Small-B) again that was once programmed and then deleted, by
copying the programmed data of PLU 90601 (Drink Small-A):
Key Operation Mode Lock: SET, enter 4, depress the [X] key.
90701 [PLU] (PLU Code of the copy-destination)
[NS]
90601 [PLU] (PLU Code of the copy-source)
2 [ST] (Address 2, Name changed into: Drink Small-A)
404 [#] (D)
702 [#] (r)
609 [#] (i)
614 [#] (n)
611 [#] (k)
[#] (Space)
503 [#] (S)
613 [#] (m)
601 [#] (a)
612 [#] (l)
612 [#] (l)
213 [#] (-)
402 [#] (B)
[ST]
9 [ST] 7 [#] (Address 9, PLU Group No. changed into: 7)
[AT/TL] (to complete this submode)
7(& 6725( 7(& 6725(
 3($&+ '5,9(
3+21( 
2SHQ  DP WR  SP
&ORVHG HYHU\ :HGQHVGD\
 )5, 
3 3
 
'ULQN 6PDOO$
  
 'ULQN 6PDOO%
 


   70
OPERATION
CONDITION