Toshiba MA-1595-1 Series - Manual (Page 189)

4. READ AND RESET REPORTS EO1-11152
4.2 In-Line Reports
4- 6
TABLE OF IN-LINE REPORT OPERATIONS (continued)
RTR Declaration: ON
Report Name
Mode
Lock
Key Operation
CUSTOMER FILE READ
(for Check Track Memory type only)
• All Files Read
• All Files Reset
• Zone Files Read
• Zone Files Reset
• Individual File Read
• Zero-balance Files Read
• Credit-balance Files Read
• Debit-balance Files Read
X
Z
X
Z
X
X
X
X
15 [AT/TL]
15 [#]
→
|Zone-start File Code|
[@/FOR] |Zone-end File Code| [AT/TL]
15 [#]
→
|File Code| [@/FOR]
→
[AT/TL]
15 [#]
→
0 [AT/TL]
15 [#]
→
1 [AT/TL]
15 [#]
→
2 [AT/TL]
NOTE: When the “Process Report” is marked, the report can only be taken after taking another report which
consolidates the corresponding data to be based on. For further details, see the table and descriptions
below.
PROCESS REPORTS AND BASE REPORT DATA
The following table shows which process reports are available after which report data collections.
Reports Collection Required before Process
Report takings
(CONSOLIDATION MEMORY CAPTURE: NOTE 1)
Process Reports available
All Department Read Daily
or
All Department Reset Daily Individual Department Read Daily
All Department Read GT
or
All Department Reset GT Individual Department Read GT
Any of the following PLU reports ( NOTE 2 )
All PLU Read Daily
Zone PLU Read Daily
All PLU Reset Daily
Zone PLU Reset Daily
Individual PLU Read Daily
Inactive PLU Read Daily
Any of the following PLU reports ( NOTE 2 )
All PLU Read GT
Zone PLU Read GT
All PLU Reset GT
Zone PLU Reset GT
Individual PLU Read GT
Inactive PLU Read GT
NOTES: 1. CONSOLIDATION MEMORY CAPTURE: When an in-line read or reset report is taken on the
Master Terminal, the consolidated data is automatically stored in the Consolidation Memory of the
Master Terminal. The consolidated data stored there is not only used as the data for a Process
Report but also sent to the PC by a command from the PC when a PC is connected.
2. The process reports will be outputted based on the report data previously collected. For example,
when an “Inactive PLU Read” report is taken after a “Zone PLU Read”, only the inactive PLUs in
the designated zone will be printed on the Inactive Read Report. (Only when the PLU is in a local
file, a process report is printed. In this case, collection of data is required beforehand.)