Thermador CIT304GM - Manual (Page 21)

22
To program a cooking time of less than 10 minutes, always press 0 before selecting
the required value. Any cooking time can be programmed up to 99 minutes. After a
loss in power, the time programming function will no longer be activated.
The timer
This can be used to time periods up to 99 minutes. It is independent of the other
settings.
1. Press the TIMER symbol. 00 appears in the time programming function
display. The min and Q indicators light up.
2. Program the time using symbols 0 to 9.
The timer starts to count down after a few seconds.
A beep sounds. The 00 and min and Q indicators blink on the time program
function display. Press the TIMER symbol. The indicators and the warning sound
signal go out.
Press the TIMER symbol until the min indicator lights up and change the time with
the 0 to 9 symbols or with the + and - symbols.
Press the TIMER symbol until the min indicator lights up and then press the 0 or the
- symbol until 00 on the time programming function display.
The timer will be deactivated after a power outage.
The element automatic OFF function and the timer function can both be operated
simultaneously.
Automatic time limitation
The automatic time limitation function is activated if the element is used for
prolonged periods without any modifications being made.
The element stops heating. r, i and the residual heat warning light t/s flash
alternately on the element display.
The indicator goes out when any symbol is pressed. The element can now be reset.
When the automatic time limitation function is activated, this is controlled by the
selected heat setting (from 1 to 10 hours).
Recommendations and
warnings
It is programmed as
follows
Once the time has
elapsed
Correcting the time
Switching the timer off
Recommendations and
warnings