Teac CD-RW901 - Manual (Page 20)

0
TASCAM CD-RW901
Program playback
This function enables playback of selected tracks in any
desired order. Up to 99 tracks can be selected for pro-
gram playback.
1. When stopped, set the mode to display Program or
Mode>Program .
2. Use the number keys (0~9) on the remote control
unit to select each desired track for program
playback, then press the
ENTER key.
You can also rotate the MULTI JOG dial to select
the track number and push to enter.
The track number will be entered into the pro-
gram.
Repeat the above step 2 until the desired program is
completed. As the program is being created, the pro-
gram number and total program playing time is revised
on the display.
NOTE
If the CLEAR key is pressed, the programmed track
will be deleted from the last.
3. When program setting is completed, press the
PLAY key to begin playback of the tracks in the
programmed order.
NOTE
If the STOP key is pressed without first pressing the
PLAY key, all the program data will be erased.
When stoppped, if the playback mode is switched
to another, all the program data will be erased.
The programmed play order is not memorized when
power is turned off.
In this mode, if there are no tracks programed, the
CD-RW901 will not start playback.
If an attempt is made to enter more than 100 pro-
gram steps, the message PGM Full! appears on the
display.
If the total program playing time exceeds 999 min
9 sec, --- : -- appears on the display.
Time display switching
When the TIME key on the front panel or the remote
control is pressed, the time display will switch through
several modes on the display.
Elapsed track time (no display light indication)
Remaining track time (
REMAIN is lit in the display)
Elapsed disc time ( TOTAL is lit in the display)
Remaining disc time ( TOTAL and REMAIN are lit in the
display)
When stopped, the total recording time is shown,
regardless of the status of the TOTAL and REMAIN indi-
cators.
•
•
•
•
NOTE
In program mode, pressing the TIME key displays
the elapsed and the remaining time of the whole
program.
When playing an MP disc, elapsed track time is al-
ways displayed, and the TIME key cannot be used.
For details on time display during recording, please
refer to “Time display while recording” in “Record-
ing” section on page .
Even when power is turned off, the time display
mode setting is retained.
Single-track playback
Random playback
In this mode, the unit will play back all the tracks on
the disc in completely random order, regardless of track
number.
When stopped, set the mode to display Program or
Mode>Random . Press the PLAY key and random playback
will begin.
NOTE
Even when the power is turned off, the unit will re-
main in Random mode.
This function enables playback of just a single track.
1. When stopped, set the mode to display Single or
Mode>Single .
2. Use the SKIP keys or the number keys (0~9) on
the remote control to select the desired track.
The MULTI JOG dial can be used to select the
track also.
3. Press the PLAY key to begin playback.
After the selected track finishes, playback stops.
4 − Playback operations