Teac CD-RW901 - Manual (Page 27)

TASCAM CD-RW901

Advanced recording
Fade-in and fade-out recording
At the beginning and end of recording, fade-in and
fade-out effects can be performed.
1. When stopped or when in recording standby
mode, set the operation using the following menu
options on the REC sub-menu (see “Operation
basics” on page 16).
FADE IN?
The length of the fade in to the normal level can be
set between 1 and 30 seconds in 1-second increments
(default setting: 3 seconds).
FADE OUT?
The length of the fade out into complete silence can
be set between 1 and 30 seconds in 1-second incre-
ments (default setting: 3 seconds).
The display shows Fade Out>XXs or Fade
In>XXs .
2. In recording standby mode, press the FADER key
on the remote control.
Recording begins and the sound fades in. After
the preset fade-in time, the sound is at normal
level.
3. During recording, press the FADER key on the
remote control when you wish to fade-out the
sound.
Fade-out begins with Fade Out flashing on the
display then the unit enters recording standby
mode.
4. Press the STOP key and the PMA writing will
begin.
NOTE
Fade-in or fade-out function can be operated only
by pressing the FADER key on the remote control
unit.
Synchronized recording
Synchronized recording basically means that recording
will begin automatically when a signal is received, and
will stop when the signal ends.
Use the SYNC REC key to select the synchronization
mode. The synchronization mode determines the auto-
mated start and stopping of recording when a signal is
received.
The SYNC indicator appears on the display.
Starting playback of the source automatically starts
recording on the CD-RW901 if Sync function is on (see
“Sync recording” below) and manual record start is dis-
abled.
Sync recording
1. While recording standby mode, press the SYNC
REC key.
2. Set the signal detection threshold level. Use the
SYNC LEVEL option in the REC sub-menu (see
“Operation basics” on page 16).
Rotate the MULTI JOG dial to adjust the level.
The level can be set from -72 dB to -24 dB in 6
dB increments. The default setting is -24 dB.
Press the MENU key or push the MULTI JOG dial
to enter and return to recording standby mode.
3. Input the source signal.
Recording begins automatically when the source
signal is detected. The source signal should be
higher than the adjusted threshold level.
S_LVL
Start of recording level
time
Noise level
NOTE
After SYNC is set, over one second of silence which
is under the adjusted threshold level is required to
start recording automatically. Otherwise, the unit
does not begin recording even if it is detecting a
signal.
5 − Recording