Tyco Electronics P5200 - Manual (Page 66)

MM23772, Rev. F
66
METHOD 2: (P7270, P7250, and P5250 model radios) From keypad: If group selection is
programmed as the primary function of  and  select a group by pressing
 or  to scroll through the group list. The display registers the new group
name on line two.
METHOD 3:
(P7270 model radios) Direct Access: Press  to enter the group select mode.
Press the numeric key mapped to the desired group. Press  . The radio will
move to the selected group.
METHOD 4:
(P7230 model radios only) If programmed for groups, press the  button to
change groups. The display registers the new group name on line two. If
programmed for channels, press the  button to change the channel. The
display registers the new channel.
9.11 MODIFY SCAN LIST
9.11.1 P7270 Model
1. Press
to toggle scan OFF and verify is not displayed.
2. Select group or channel.
3. Press  once to remove group or channel from list.
4. Press once to add as a normal group or channel.
5. Press twice to add as a Priority 2 group.
6. Press three times to add as a Priority 1 group.
7. Press to re-start scanning.
9.11.2 P7250 and P5250 Models
1. Press  to toggle scan OFF and verify is not displayed.
2. Select group or channel.
3. Press  once to remove group or channel from the list.
4. Press  once to add as a normal group or channel.
5. Press

twice to add as a Priority 2 group.
6. Press  three times to add as a Priority 1 group.
7. Press

to re-start scanning.