Tyco Electronics P5200 - Manual (Page 80)

MM23772, Rev. F
80
any index other than 0 or toggle between the two lists by pressing the  key. If wrap is enabled, the
calls received list wraps on itself and not into the other list.
Figure 9-12: Calls Received and Personality Lists
The saved call list shows all ten storage locations. If no calls have been received, the saved call list will be
empty and the pre-stored list will be available upon entering the individual call mode.
When in the saved call list, pressing the  key toggles the time stamp ON and OFF. The time stamp
indicates how long ago the call was received. When in the pre-stored list pressing the

key toggles the
Logical IDentification (LID) ON and OFF.
9.24 TELEPHONE INTERCONNECT CALLS
9.24.1 Receive a Telephone Interconnect Call
When the radio receives a telephone interconnect call (a call directed only to the user's radio), it un-mutes
on the assigned working channel and displays . The first line displays
*PHONE*
. The second line
displays
*INDV*
. Proceed with the call. Press PTT to talk, release PTT to listen.
9.24.2 Send a Telephone Interconnect Call
9.24.2.1 Pre-Stored Number
Use the following procedures to initiate and complete a Telephone Interconnect call:
1. System Model: To select a previously stored phone number, press

. Use the

or

keys to
scroll through the list of stored numbers.
Scan Model: To select a previously stored phone number, press  . Use the  or  keys to select
the menu option
PHN CALL
. Press the  key again then use the  or  keys to scroll through the
list of pre-stored numbers.
2. Press and release the PTT button. When the radio is clear to transmit, turns ON, turns OFF and
the channel access tone sounds. Line one shows the accompanying name selected from the list of
stored numbers. The message
*PHONE*
displays on line two. The radio then automatically transmits
the programmed number stored in the special call queue.