Toshiba 6100 - Manual (Page 161)

8-7
O
PTIONAL
D
EVICES
Memory expansion
2. Do not try to install a memory module with the
computer turned on or turned off in Standby and
Hibernation mode. You can damage the computer and
the memory module.
3. If you install a memory module that is not compatible
with the computer, a beep will sound when you turn
on the power. If the module is installed in slot A, there
will be a long beep followed by a short beep. If the
module is in slot B, there will be a long beep followed
by two short beeps. In this case shut down the power
and remove the incompatible module.
2. Remove all cables connected to the computer.
3. Turn the computer upside down and remove the battery pack (refer to Chapter
6, Power and Power-Up Modes .)
4. Remove two screws securing the memory module cover.
5. Lift off the cover.
NOTE: Use a point size 0 Phillips screwdriver.
Figure 8-6 Removing the cover
6. Insert the memory module into the connector on the computer. Press the
module carefully and firmly to ensure a solid connection.