Toshiba 6100 - Manual (Page 169)

8-15
O
PTIONAL
D
EVICES
External monitor
6. Turn on the printer.
7. Turn on the computer.
8. Start the Hardware Setup program. Refer to Chapter 7 HW Setup and Pass-
words .
9. Select the Parallel/Printer tab from the TOSHIBA HW Setup
window.
10. Set the Parallel Port Mode and press OK .
11. Choose Reboot for the change to take effect.
12. Select the printer in Windows Add Print Wizard. To access the Add Print
Wizard utility, click Start , point to Settings , click Printers and double
click the Add Printer icon.
External monitor
An external analog monitor can be connected to the external monitor port on the
computer, Port Replicator. The computer supports VGA and Super VGA video
modes. To connect a monitor, follow the steps below.
CAUTION: If an external monitor is connected to the computer, do not
connect the Port Replicator. First disconnect the external monitor from
the computer then connect the Port Replicator and use its external
monitor port.
NOTE: The Resume feature can be used with an external monitor. Simply
enable Resume and the computer will maintain the data as it is displayed
on the external monitor.
1. Connect the monitor to the external monitor port.
2. Turn the monitor’s power on.
When you turn on the power, the computer automatically recognizes the monitor
and determines whether it is color or monochrome.
You can use the HW Setup to select between Auto-Selected and
Simultaneous displays. Refer to Chapter 7, HW Setup and Passwords .
If you have selected Simultaneous under the Display options of the HW
Setup, both the external monitor and the internal LCD will be active when you turn
on the computer. If
Auto-Selected is selected, only the external monitor will be
active.