Transcend Information SSD25S - Manual (Page 18)

T T T S S S 8 8 8 G G G S S S S S S D D D 2 2 2 5 5 5 S S S - - - S S S
T T T S S S 1 1 1 6 6 6 G G G S S S S S S D D D 2 2 2 5 5 5 S S S - - - S S S / / / M M M
T T T S S S 3 3 3 2 2 2 G G G S S S S S S D D D 2 2 2 5 5 5 S S S - - - S S S / / / M M M
T
T T S
S S 6
6 6 4
4 4 G
G G S
S S S
S S D
D D 2
2 2 5
5 5 S
S S -
- - S
S S /
/ / M
M M
T
T T S
S S 1
1 1 2
2 2 8
8 8 G
G G S
S S S
S S D
D D 2
2 2 5
5 5 S
S S -
- - M
M M
T
T T S
S S 1
1 1 9
9 9 2
2 2 G
G G S
S S S
S S D
D D 2
2 2 5
5 5 S
S S -
- - M
M M 2.5” Solid State Disk
Transcend Information Inc.
V1.08
18
ATA Command Specifications
CHECK POWER MODE (E5h)
The host can use this command to determine the current power management mode.
EXECUTE DIAGNOSTICS (90h)
This command performs the internal diagnostic tests implemented by the drive.
FLUSH CACHE (E7h)
This command is used by the host to request the device to flush the write cache. If there is data in the write cache, that
data shall be written to the media. The BSY bit shall remain set to one until all data has been successfully written or an
error occurs.
FLUSH CACHE EXT (EAh)
48-bit feature set mandatory command. This command is used by the host to request the device to flush the write cache.
If there is data in the write cache, that data shall be written to the media. The BSY bit shall remain set to one until all data
has been successfully written or an error occurs.
IDENTIFY DEVICE (ECh)
This commands read out 512Bytes of drive parameter information. Parameter Information consists of the arrangement
and value as shown in the following table. This command enables the host to receive the Identify Drive Information from
the device.