Transcend Information SSD25S - Manual (Page 37)

T T T S S S 8 8 8 G G G S S S S S S D D D 2 2 2 5 5 5 S S S - - - S S S
T T T S S S 1 1 1 6 6 6 G G G S S S S S S D D D 2 2 2 5 5 5 S S S - - - S S S / / / M M M
T T T S S S 3 3 3 2 2 2 G G G S S S S S S D D D 2 2 2 5 5 5 S S S - - - S S S / / / M M M
T
T T S
S S 6
6 6 4
4 4 G
G G S
S S S
S S D
D D 2
2 2 5
5 5 S
S S -
- - S
S S /
/ / M
M M
T
T T S
S S 1
1 1 2
2 2 8
8 8 G
G G S
S S S
S S D
D D 2
2 2 5
5 5 S
S S -
- - M
M M
T
T T S
S S 1
1 1 9
9 9 2
2 2 G
G G S
S S S
S S D
D D 2
2 2 5
5 5 S
S S -
- - M
M M 2.5” Solid State Disk
Transcend Information Inc.
V1.08
37
WRITE MULTIPLE EXT (39h)
48-bit feature set mandatory command. This command is similar to the Write Sectors command. Interrupts are not
presented on each sector, but on the transfer of a block which contains the number of sectors defined by Set Multiple
command.
WRITE MULTIPLE FUA EXT (CEh)
48-bit feature set mandatory command. This command provides the same functionality as the WRITE MULTIPLE EXT
command except that regardless of whether volatile and/or non-volatile write caching in the device is enabled or not, the
user data shall be written to non-volatile media before command completion is reported.
WRITE SECTOR(S) (30h/31h)
Write data to a specified number of sectors (1 to 256, as specified with the Sector Count register) from the specified
address. Specify “00h” to write 256 sectors.
WRITE SECTOR(S) EXT (34h)
48-bit feature set mandatory command. Write data to a specified number of sectors (1 to 65536, as specified with the
Sector Count register) from the specified address. Specify “00h” to write 65536 sectors.