Teledyne 6712SR - Manual (Page 142)

6712SR Refrigereated Sampler
Section 7 Remote Operation
7-2
7.1.1 Menu Control Menu commands can be entered from a remote location using a
computer. The menu commands are listed in Table 7-1.
To access the menu commands, type MENU at the “>” prompt
and press ENTER. The screen will return a list of the available
options. Note that the current state of the controller will
determine the available menu options. Then, type the desired
command(s), confirming with ENTER.
Table 7-1 6712 Remote Menu Commands
Menu Command Description
0 or START This command will start immediately any program that has been run and is currently waiting to
start.
1 or RUN1 This command will load Program 1 as the sampler’s current Extended program, reset partition if
the storage interval has been changed, and run the program. RUN1 is valid when the sampler
is in standby, or when it is waiting for a start command. RUN1 will also run the current program
while in Standard programming.
2 or RUN2
3 or RUN3
4 or RUN4
These commands will load the selected program number as the sampler’s current Extended
program, reset partition data if the storage interval has changed, and run the program. They are
valid when the sampler is in standby, or when it is waiting for a start command. The commands
are available for Extended programming only.
5 or DISABLE This command is similar in functionality to a pin F low signal (a signal typically used to enable or
disable the sampler from a flow meter). At run time, the sampler starts with the sampler in the
enabled state. DISABLE is valid while a program is running. If successful, a display of REMOTE
ENABLE IS FALSE will be returned.
A Remote Disable is the highest priority disable. If the sample is disabled with this command,
no condition other than menu command 6, ENABLE, will allow the program to become enabled
again.
6 or ENABLE This command is used to re-enable a disabled sampler. ENABLE is valid while a program is
running. If successful, a display of REMOTE ENABLE IS TRUE will be returned.
7 or TAKE_SAMPLE This command causes the sampler currently running a program to take a sample. The sample
will count as one of the program’s samples and is placed in the current bottle (Part A’s current
bottle when using two-part programming). TAKE_SAMPLE is valid while the program is run-
ning, after the start time, but not while in the MANUAL PAUSE screens. If successful, a
response similar to PUMPING XXML SAMPLE INTO BOTTLE ## will be returned. If not, a
response similar to NO SAMPLE, PROGRAM WAITING START will be returned.
ST or STATUS This command causes the sampler to return its status information and current parameter data.
SD or
SCREEN_DUMP This command causes the sampler to return the information currently displayed on the sam-
pler’s screen. The remote screen follows the sampler’s display as the information is updated.
This mode can be used to observe from a remote location while the sampler is programmed
on-site.
P or PAUSE This command causes a sampler currently running a program to enter the MANUAL PAUSE
menu. While you are connected in this mode, the sampler keypad becomes disabled, and your
computer’s keypad will be redirected to simulate the sampler keypad. The following keys will be
activated:
<Enter>, decimal point, and number keys.
<Esc>, S, or s = STOP.
<Backspace>, L or l, and U or u = Left/Up arrows.
R or r, and D or d = Right/Down arrows.