Teac CR-H500NT - Manual (Page 23)

ENGLISH
23
To check the programmed order
In the stop mode, press the PROGRAM but ton
repeatedly. The track/file number and programme
number will be shown on the display.
To change or add a track/file to the
programme
In the stop mode, press PROGRAM button repeatedly
until the program number for which you want to
change the track/file appears on the display. Then
select a track/file using the scroll buttons (
5/b). The
previous track/file is replaced with the newly selected
one.
If you want to add a track /file to the end of the
programme, press the PROGRAM button repeatedly
until “P-END” briefly appears on the display. Then
select a track/file using the scroll buttons (
5/b). The
track/file is added to the programme.
To delete a track/file from the
programme
In the stop mode, press the PROGRAM but ton
repeatedly until the programme number appears
to be deleted on the display, then press the CLEAR
button. The selected track/file is deleted from the
programme.
To clear the programme
1. In the stop mode, press the PROGRAM button.
2. Hold down the CLEAR button for more than 4
seconds.
< In the following cases, the programmed contents will
also be cleared:
pressing the STANDBY/ON button
opening the disc tray
disconnecting the AC power cord
EN_CR-H500NT_T_C.indb 23 EN_CR-H500NT_T_C.indb 23 09.10.6 5:31:31 PM 09.10.6 5:31:31 PM