Ultra electronic 3503-1002 - Manual (Page 13)

Ultra Electronics Card Systems Quick Start Guide
MAGICARD Sprinter Flip Page 13
Flex a stack of plastic cards, to make
sure they are not 'stuck' together. Avoid
touching the surfaces to be printed.
Remove the 'tacky' roller before each
batch of 100 cards, by putting your
fingers beneath it and "snapping" out the
left hand end of the roller. Remove
surface dust by using a strip of 'Scotch'
adhesive tape, and "snap" back into
place.
Load the
Plastic Cards
E
1
3a
2