Ultra electronic 3503-1002 - Manual (Page 17)

Ultra Electronics Card Systems Quick Start Guide
MAGICARD Sprinter Flip Page 17
At the rear of the printer, locate the TEST
Push-button. This is located in the rear
panel, just above the Centronics parallel
interface connector.
Press the push-button momentarily.
It will take a few seconds before printing
commences. When finished, a Test Card
will be ejected from the aperture in the
Front Panel.
The card should be as shown, with
Yellow-Magenta-Cyan-Black panels, a
Cyan background and Yellow-Magenta-
Cyan graduated scales. This card can
only be printed by a printer in isolation,
when using UR1 Dye Film
Test the
Printer Operation
Print an Internally-Generated Test Card to make
sure your printer is working correctly:
G
1 2
3