Connect the printer to a power supply – Ultra electronic 3503-1002 User Manual
Page 16
Advertising

Quick Start Guide
Ultra Electronics Card Systems
Page 16
MAGICARD Sprinter Flip
Locate the ON/OFF Switch and check that
it is in the OFF position.
Switch ON. The indicators should all
flash and the motors run briefly. Finally,
the POWER ON and ON LINE indicators
will remain ON..
Plug in the Power Cord. Plug the other
end into a power socket.
Connect the Printer
to a Power Supply
F
1
3
2
Advertising
This manual is related to the following products: