Unified Brands HYPERSTEAM (2)HY-5G - Manual (Page 10)

OM-HY-5G
10
Operation
WARNING
ANY POTENTIAL USER OF THE EQUIPMENT MUST BE TRAINED IN SAFE AND CORRECT OPERATING
PROCEDURES.
A. Controls
Operator controls are on the front right of the unit.
The HY-5G control panel has the following touch
pads and indicator lights:
! The ON/OFF touch pad gets the
HyPerSteam ready for use, or shuts it off.
! The READY indicator light shows that the
steam generator is at standby temperature
and the cavity is hot enough to begin
steaming.
! The CLEANING indicator light is lit when the
unit is operating in the cleaning mode.
! The SERVICE indicator light shows when
the water level probes have stopped
working, and need to be cleaned (normally
an indication of lime deposits).
When one probe fails, the SERVICE light
flashes briefly every few seconds, but the
unit will continue to operate. De-lime the unit
as soon as possible.
If the problem continues, both probes may
fail. Then the steamer stops working, the
light will flash repeatedly and the beeper will
sound. At this point you must turn off the
power and contact an Authorized Groen
Service Representative for repair.
! The HI TEMP indicator light comes on when
the steam generator is too hot.
The unit will automatically shut off, and
cannot be turned on again until the steam
generator cools and the HI TEMP indicator
light goes out.
! The TIMING indicator light stays on when
the timer is running.
! The CLEAN touch pad is used to start the
automatic 50 minute cleaning cycle.