Ultimate Technology 500 POS - Manual (Page 30)

22
Table 3. Local Mode Programming Instructions - Continued
Note: *Default Settings
Function Code(s) Operation Normal Indication Remarks
the Programmer's card. If using the optional 3- position keyswitch,
move switch out of the AUX position.
14
15
16
Magnetic Stripe
Reader (MSR)
Channel 2
Prefix (14)
Field
Separator (15)
Suffix (16)
1. While in programming mode, at the Series 500 Keyboard numeric
keypad, enter applicable Function Code 14, 15, or 16.
LED (2) flashes.
2. At the auxiliary keyboard, press the desired key or type the desired key
sequence. Note that the maximum number of key codes is limited to 24
- this is equivalent to approximately 12 key strokes.
If the Series 500 Keyboard
beeps and LED (2) turns off
while entering key codes at the
auxiliary keyboard, you have
exceeded 24 key codes. Repeat
steps 1 and 2.
3. At the Series 500 Keyboard, press ENTER.
LED (2) turns off.
4. Program the next function code or exit programming mode by entering 99
on Series 500 Keyboard numeric keypad or by swiping the Programmer's
card. If using the optional 3-position keyswitch, move switch out of the
AUX position.
17
18
Magnetic Stripe
Reader (MSR)
Channel 1,3
Bad Read (17)
Channel 2
Bad Read
Macro (18)
1. While in programming mode, at the Series 500 Keyboard numeric
keypad, enter applicable Function Code 17 or 18.
LED (2) flashes.
2. At the auxiliary keyboard, press the desired key or type the desired key
sequence. Note that the max imum number of key codes is limited to 24
- this is equivalent to approximately 12 key strokes.
If the Series 500 Keyboard
beeps and LED (2) turns off
while entering key codes at the
auxiliary keyboard, you have
exceeded 24 key codes. Repeat
steps 1 and 2.
3. At the Series 500 Keyboard, press ENTER.
LED (2) turns off.