Universal Electronics Atlas DVR/PVR 5-Device - Manual (Page 14)

www.urcsupport.com
14
4. On the original remote, press and hold the key
to be learned. The Atlas DVR/PVR 5-Device
Universal Remote Control with Learning’s
LED will blink rapidly, then turn off. Continue
holding the key on the original remote until
the Atlas DVR/PVR 5-Device Universal
Remote Control with Learning’s LED blinks
twice.
NOTE: If the LED displays one long blink, a learning
error has occurred. Try repeating this step
again until a successful capture occurs. If the
function is
still not captured, press and hold
SETUP to exit programming and review the
“Learning Precautions” on the previous page.
If needed, also see “Troubleshooting” on
page 22. After review, start programming
again at step 1.
Deleting a Single Learning Key
This process returns the key to its original programming
for the mode you select. You can also delete learned
programming by teaching a different function to the key
(see “Programming a Learned Key” on page 13)
NOTE:
If more than 15 seconds pass between key
presses, the remote exits programming.
3. Press the key containing the learned function
to be deleted twice. The remote will blink
twice.
5. Repeat steps 2 through 4 for another mode
and/or key or press and hold SETUP to exit
programming.
1. Press and hold SETUP until the last-selected
mode key blinks twice, then press 9 7 6.
2. Press a mode key once (i.e., AUX, DVD, AUD,
TV, or CBL).
4. Repeat steps 2 through 3 for another key or
press and hold SETUP to exit programming.