Access to ata when the dhcp is not working – UTStarcom IAN-02EX User Manual

Page 6

background image

Telephone’s Analogue Adapter – UTStarcom iAN-02EX (V1.8.2.17a) – Operating Manual


Access to ATA when the DHCP is not working

1. configure the static IP address on the LAN port of your PC.

Click on “Start \ Settings\ Network connections“, double
click on “Local area connections (LAN)” .

In the new window click on “Properties” and then double
click on “Internet Protocol (TCP/IP)”.

Verify that the option “Use the following IP address” is
activated, or modify the setting and fill in the following
IP address: 192.168.0.x (in the example of the right site,

it is used the address

Subnet mask:
Default gateway:
For DNS servers should be used the IP addresses
provided by the Internet Service Provider.
Once finished the configuration, press “OK” and close all
the opened windows.

2. start your Web Browser (i.e. Internet Explorer), insert the IP address and press “GO”.

6. It will appear the window prompt for “Network Password”

in which you have to insert “supervisor” as User name and
your personal Password, received from Eutelia, as
Password (if you didn’t receive any indication, use the
“Eutelia” password).

Attention! The confidentiality of these data is necessary
in order to guarantee that the equipment configuration is
accessible only by you. We suggest to proceed with the
configuration password change and to write down the
new one.

3. After few moments, the “System Status” of your iAN-

02EX ATA.will appear on the left of your window. Clicking
on the items of the menu you can change the parameters
configuration of your iAN-02EX, as explained in the
following chapter.

IMPORTANT: the changes made are not going to be effective before “Save” and “Reboot” of the ATA, as indicate in the
following pages.