Fagor 6FI-4GLSX - Manual (Page 11)

OPERATION
UK 10
 For the proper operation ensure that burners and igniters are clean and dry.
 If the hob is equipped with a flame failure protection after igniting the burner keep the control
knob fully pushed for a while to activate the protection.
 Do not overload the grates.
 Never touch hot burners, graters, pots and pans.
 To obtain proper and economical burners operation make sure that:
 flame height is adequate,
 pots and pans are properly selected.
Burner without
flame failure
protection Burner with
flame failure
protection
Fig. 14
3.1.1 FLAME ADJUSTING
 Gas flow in individual burners is opened and closed using control knobs.
 Before igniting the burner make sure that the corresponding control knob is to be operated.
 Corresponding burners and control knobs are shown in Fig. 15.
 Flame height depends on the control knob position (Fig. 16). Adjust the flame only between and
.
 Flame should not spread beyond the bottom of the vessel but spread on 2/3 of the vessel’s bottom.
This will ensure gas efficiency and the flame will not singe pots and pans.
 When the control knob is in position the flame is high. High flame should be used until a liquid
starts boiling and then turn down the flame to small (economical) for further cooking.
0 – burner turned off; – high flame; – small flame
(economical)
Fig. 15 Fig. 16
3.1.2 IGNITING BURNERS
Hobs: 6FID-31MLX; 6FID-4GLX; 6FID-4GLB
 push the knob of a burner until it stops, then turn it anticlockwise and push down until the burner
ignites
 after ignition release the knob
 adjust to the desired flame height between and
Hobs: 6FI-4GLSX; 6FID-4GLSX; 6FI-4GLSTX;6FID-31MLSX
 push the knob of a burner until it stops, then turn it anticlockwise and push down until the burner
ignites, do not release the knob for another 5 seconds in order to activate flame failure
protection