Fagor 6FI-4GLSX - Manual (Page 14)

OPERATION
UK 13
Cooking Roasting
Turn the knob to position 6 and wait till the
liquid starts boiling and turn to position 2 for
further cooking. Adjust heating power
accordingly. Turn the knob to position 6 and heat the oil.
Then put ingredients into vessel and turn the
knob to position 4. Adjust heating power
accordingly.
ATTENTION !
After switching off the plate remains hot for some time. Do not touch the plate or
place any vessels or objects on it. Pay special attention to children.
 It is recommended to switch the electric plate off for 5 to 10 minutes before finishing boiling to make
full use of its final power.
 Do not put unused vessels on the electrical plate.
3.2.3 VESSEL SELECTION
 Pots and pans put on the electrical plate should have thick flat and dry bottoms with a diameter equal
or slightly larger than the plate diameter. Large amount of heat is wasted if the vessel bottom has a
smaller diameter.
 Uneven bottoms extend boiling time and raise power consumption.
 Vessel should be covered to prevent accumulating too much fumes in the kitchen.
Fig. 21 Correct !

Low power consumption

Good heat conducting

even bottom of the vessel

bottom diameter is the same as plate diameter

cover tightly adheres to the vessel
Incorrect !

High power consumption

Poor heat conducting

Long cooking time
Vessel too small Uneven vessel bottom Dirty plate surface
Fig. 22