Ultra electronic Prima 3 XID590ie - Manual (Page 81)

Step 6: Exchange the card sides
As seen in the last step, for non-blank cards, the position of the magnetic stripe or contact chip or
both must be adjusted to fit the layout. While the Rotation-button rotated the card on both sides,
the Exchange-button allows to swap the front and back sides if the magnetic stripe or the chip are
shown at the wrong side of the layout.
Magnetic stripe:
The stripe can either be on the front or the back side of the layout.
Contact chip:
The chip can either be on the front or the back side of the layout.
The following illustrations show some examples of magnetic stripe and chip cards and a
combination of both types and the effect of the rotate-button.
Note: The same applies for one-sided cards.
Magnetic stripe
Contact chip
+ +
+ +
Magnetic stripe + contact chip
+
+
Prima 3 Driver Manual
81