Setting the channel delay time, Setting id scan/search (trunked systems only), Setting id scan/search (trunked systems – Uniden BC246T User Manual
Page 64: Setting id scan/search, Trunked systems only), Programming/editing optional settings
64
Programming/Editing Optional Settings
Notes:
• If you select 0, the scanner stays on the system for a
minimal time (only long enough to check current
system activity).
• The default setting is 2 seconds for each system.
• For conventional systems, all unlocked channels will
be scanned at least once regardless of this setting.
• The scanner moves to the next system after the hold
time expires, any current transmission ends, and the
channel delay time expires.
• Due to the control method for these system types, the
scanner always scans LTR and EDACS SCAT sys-
tems for at least 1 second.
Setting the Channel Delay Time
program system
E
Select the system
E
Edit Sys Option
E
Set DELAY Time
E
This setting controls how many seconds the scanner
waits after a transmission ends before resuming
scanning. Enter a value from 1-5 or Off, then press E.
Notes:
• The default setting is 2 seconds for each system.
• This setting applies to all channels within the system.
Setting ID Scan/Search
(Trunked Systems Only)
program system
E
Select the system
E
Edit Sys Option
E
ID SCAN/SEARCH
E
This setting controls how the system will be scanned.
Select your setting, then press E.
Menu
Menu