Finding repeater output frequencies, Setting the maximum auto store value, Setting the modulation type – Uniden BC246T User Manual
Page 91: Search and close call options
91
Search and Close Call Options
Finding Repeater Output Frequencies
Srch/CloCall Opt
E
Repeater Find
E
This feature sets whether the scanner tries to tune to a
repeater output frequency during Close Call operation
when it detects a transmission on a repeater input
frequency. Since you can normally only hear one side of a
conversation when you listen to an input frequency
transmission, turning this feature on can let you hear both
sides of the conversation.
On
The scanner automatically applies repeater reverse to
detected transmissions. If the scanner detects the
transmission on the output frequency, it beeps, REPEATER
FIND
appears, and it remains on the output frequency until
transmissions end. If it does not detect a transmission on
the output frequency, it remains on the original frequency.
Off
The scanner does not try to find the output frequency.
Setting the Maximum Auto Store
Value
Srch/CloCall Opt
E
Max Auto Store
E
This value sets how many hits the scanner will
automatically store when it is in either Search and Store
or Close Call Auto Store mode.
Use the number keys to enter a value from 1 - 256, then
press E.
When the scanner reaches the maximum number of hits
you set, it stops the auto-store operation.
Setting the Modulation Type
Srch/CloCall Opt
E
Set Modulation
E
Menu
Menu
Menu