Uniden uh049sx-2 - Manual (Page 15)

14
UNIDEN Model uh049sx UHF CB Radio
OPERATION
TRANSMIT POWER SELECT
The uh049sx has three transmit power levels: 1 Watt, 0.5 Watt and 0.1 Watt. To
change your transmit power level:
1. Press while in the ’power middle level’ to change to
’power high level.’
2. Press while in the ’power high level’ to change to the
’power low level.’
3. Press while in the ’power low level’ to change to
’power middle level.’
TX Power Low TX Power Middle TX Power High
Transmitting on a higher level will use more Battery power but
will enable you to transmit further.
SCANNING
The uh049sx has two types of scanning; Open Scanning (OS) and Group Scanning
(GS), OS Scan searches all the channels and frequencies in its memory continu-
ously. GS Scan has the ability of monitoring a priority channel every 1.5 seconds
while searching channels and frequencies in
its memory.
Scanning allows you to search for active
channels programmed in the OS or GS
memory.
To initiate scanning,
1. Assuming the unit is on CH01
when switched on.
2. Press
DUAL
and scanning starts.
Scan icon flashes during scanning.
uh049sx OM.indd Sec1:14 uh049sx OM.indd Sec1:14 17/8/07 3:01:09 PM 17/8/07 3:01:09 PM