Uniden MHS550 - Manual (Page 21)

Uniden MHS550 Radio Owner’s Manual 19
the battery case, check the rubber seal. Make sure the
seal is seated in the groove and there is no dirt or
debris on it. If the rubber seal looks worn or damaged,
contact customer service to order a replacement (see
back cover for contact information).
Install the alkaline battery case in your radio just as
you do the Li-Ion battery (see page 17).
Warning: The case is designed to prevent the
accidental charging of alkaline batteries. Never use
alkaline batteries in the radio without the battery case.
Do not attempt to modify the battery case design.
Attaching the belt clip
To attach the belt clip:
Hold the belt
clip so that
the finger
indentation
points to the
top of the
radio.
Align the center of the clip with the anchor post.
Place the clip on the post and slide the clip upwards
until it clicks into place.
To remove the belt clip:
Rotate the
clip so that
the finger
indentation
is towards
the bottom
of the radio.
Slide the clip up until it comes free of the anchor post.
5.
1.
2.
3.
1.
2.
VOL
SQ
VOL
SQ
VOL
SQ
VOL
SQ
VOL
SQ
VOL
SQ
VOL
SQ
VOL
SQ