Uniden DXAI5688 - Manual (Page 58)

57
Important.Safety.Instructions
When using your telephone equipment, basic safety
precautions should always be followed to reduce the risk of fire,
electric shock and injury to persons, including the following:
. Do not use this product near water, for example, near a
bath tub, wash bowl, kitchen sink or laundry tub, in a wet
basement or near a swimming pool.
2. Avoid using a telephone (other than a cordless type) during
an electrical storm. There may be a remote risk of electric
shock from lightning.
3. Do not use the telephone to report a gas leak in the vicinity
of the leak.
4. Use only the power cord and batteries indicated in this
manual. Do not dispose of batteries in a fire. They may
explode. Check with local authorities for possible battery
disposal instructions.
5. Do not disassemble any component of this product.
SAVE.THESE.INSTRUCTIONS
CAUTION!
Risk of explosion if battery is replaced by an incorrect type.
Dispose of used batteries according to the instructions. Do not
open or mutilate the battery, and disconnect the battery before
shipping this product.
The.FCC.Wants.You.To.Know
This equipment complies with Part 68 of the FCC rules and the
requirements adopted by the ACTA.
On the bottom of this equipment is a label that contains,
among other information, a product identifier in the format US:
AAAEQ##TXXXX. If requested, this number must be provided
to the telephone company.
An applicable Universal Service Order Codes (USOC)
certification for the jacks used in this equipment is provided (i.e.,
RJC) in the packaging with each piece of approved terminal
equipment. A plug and jack used to connect this equipment to
the premises wiring and telephone network must comply with
the applicable FCC Part 68 rules and requirements adopted by
the ACTA.
A compliant telephone cord and modular plug is provided with
this product. It is designed to be connected to a compatible
modular jack that is also compliant. See installation instructions
for details.
The REN is used to determine the number of devices that
may be connected to a telephone line. Excessive RENs on a
telephone line may result in the devices not ringing in response
to an incoming call. In most but not all areas, the sum of RENs
should not exceed five (5.0). To be certain of the number of
devices that may be connected to a line, as determined by
the total RENs, contact the telephone provider. For products
approved after July 23, 200, the REN for this product is part of
the product identifier that has the format US:AAAEQ##TXXXX.
The digits represented by ## are the REN without a decimal
point (e.g., 03 is a REN of 0.3). For earlier products, the REN is
separately shown on the label.