Uniden DXAI5688 - Manual (Page 60)

59
the unlikely event that you consistently hear other voices or
distracting transmissions on your phone, you may be receiving
radio signals from another cordless telephone or other source
of interference. If you cannot eliminate this type of interference,
you need to change to a different channel. Finally, it should be
noted that some cordless telephones operate at frequencies
that may cause interference to nearby TVs and VCRs. To
minimize or prevent such interference, the base of the cordless
telephone should not be placed near or on top of a TV or VCR.
If interference is experienced, moving the cordless telephone
farther away from the TV or VCR will often reduce or eliminate
the interference.
Cordless.Telephone.Privacy
Cordless telephones are radio devices. Communications
between the handset and base of your cordless telephone
are accomplished by means of radio waves which are
broadcast over the open airways. Because of the inherent
physical properties of radio waves, your communications can
be received by radio receiving devices other than your own
cordless telephone unit. Consequently, any communications
using your cordless telephone may not be private.
I.C..Notice
Terminal.Equipment
NOTICE: This equipment meets the applicable Industry Canada
Terminal Equipment Technical Specifications. This is confirmed
by the registration number. The abbreviation, IC, before the
registration number signifies that registration was performed
based on a Declaration of Conformity indicating that Industry
Canada technical specifications were met. It does not imply that
Industry Canada approved the equipment.
NOTICE: The Ringer Equivalence Number (REN) for this
terminal equipment is marked on the equipment itself. The REN
assigned to each terminal equipment provides an indication
of the maximum number of terminals allowed to be connected
to a telephone interface. The termination on an interface may
consist of any combination of devices subject only to the
requirement that the sum of the Ringer Equivalence Numbers of
all the devices does not exceed five.
Radio.Equipment
The term "IC:" before the radio certification number only
signifies that Industry Canada technical specifications were
met. Operation is subject to the following two conditions: () this
device may not cause interference, and (2) this device must
accept any interference, including interference that may cause
undesired operation of the device. "Privacy of communications
may not be ensured when using this telephone".