Univex Aquastop 800 series - Manual (Page 11)

11
Checklist for
Installation
Page
completely remove 4 transport bolt
assemblies and move the washer
into place
11
connect the water supply lines and
drain pipe
12
connect the electrical power 14
slide the washer into its final location 15
level the washer as low as possible 15
before first use, run a cleaning cycle 18
Removing the transport
bolt assemblies
d CAUTION
To avoid possible injury and damage
to the appliance and adjacent
surfaces, all four transport bolt
assemblies must be removed before
using the appliance. Retain the bolt
assemblies for use in any future
transport (e.g. when moving). If you
have purchased a pedestal
mounting kit, follow the installation
instructions provided with it before
removing the transport bolt
assemblies.
i If mounting the washer on a
pedestal, install washer on the
pedestal prior to removing the
transport bolt assemblies.
1. Loosen all four bolt assemblies
before removing any of the bolts all
the way from the unit.
2. Remove the bottom two bolt
assemblies prior to removing the
top two bolt assemblies. Remove
all four bolt assemblies in the order
shown in the diagram below.
3. Loosen the bolt assemblies using
the closed end of the 13mm
wrench provided, or a 13mm
socket wrench. Loosen them until
they can be moved freely.
4. The bolt assemblies may be easier
to remove using 13 mm socket
wrench.
5. Pull the washer drum slightly
forward towards the open washer
door to reduce pressure on the
transport bolt assemblies.
Slide each loosened transport bolt
assembly out of its retaining slot,
then pull it out through the round
hole in the housing.Completely
remove all 4 transport bolt
assemblies (each assembly
consists of a bolt, a metal flat
washer and a white plastic
bushing).
6. If the bushings do not come out
when removing the bolt
assemblies, place the bolts back
into the bushings and carefully try
again. It is important to do this
with the bolts, otherwise the
bushings will not come out
properly.
7. To store the bolt assemblies for
future use, do not remove the bolts
from the plastic bushings.
8. Position the plastic cover over the
hole the transportation bolt
assemblies occupied. Push the
tab in (A) and slide the cover
towards the small slot (B).
Storing the transport bolt
assemblies
Always keep the transport bolt
assemblies for future transportation of
the appliance (such as when moving ).
q Store the transport bolt assemblies
with the washer and bushing
attached.
q
Do not remove the bolt and
washer from the bushing.