Notice, Warning, Dimensions – Univex Aquastop 800 series User Manual

Page 8: Installation area

Advertising
background image

8

The accessory parts bag contains:

1. Covers to be placed over the holes

for the transport bolts (after
removing the transport bolts
during washer installation).

2. Wrench for leveling.
3. Clamp for drain hose.

On the back of the washer:

1. power cord with plug
2. hot and cold water connections
3. 4 shipping bolts

Useful tools

The following tools are helpful:

1. Flat head screwdriver.
2. Socket wrench13 mm
3. Closed wrench 13 mm

NOTICE

DO NOT push against the washer

door glass. Risk of breakage!

Dimensions

a = 27.0 in. (68.7 cm)
b = 29.7 in. (75.4 cm)
c = 36.8 in. (93.5 cm) (minimum)*

37.8 in. (96.2 cm) (maximum)*

d = 20.7 in. (52.5 cm)
e = 49.8 in. (126.3 cm)

* height of appliance depends upon

extension of height-adjustable feet.

Minimum height is with feet turned all

the way in, against the bottom of the

washer. Maximum height is with feet

extended as far as permitted (must

leave thread of screw engaged

enough for foot to be stable (1/4 inch /

6.4 mm) when extended).

Door opening angle 160°
Approx. weight = 220 lbs (100 kg)

Installation area

d

WARNING

Never ground the washer to plastic

plumbing lines, gas lines or hot

water pipes.

This appliance must be installed on

a solid floor and well leveled due to

the higher spin speeds available. If

installing the machine on a wood

floor over a basement or on a

second floor, the floor may need to

be reinforced. Sound, vibration, and

risk of the washer walking" will be

influenced by the structure and

stability of the floor surface where

the appliance is installed.

q

Soft floor surfaces, such as

carpets or surfaces with foam

backing, are not suitable. If

possible, place the washing

machine in a corner of the room.

If the washing machine is to be installed

on a weak wood floor, consider the

following:

q

Screw a section of water-resistant

plywood (at least 3/4" thick) to the

floor. The plywood should be

sized to fit the footprint of the

washer, approximately 27" wide x

29.7" deep, or 54" wide x 29.7"

deep to extend underneath both

the washer and the dryer for best

results and even height of the

appliances.

q

Secure the feet of the washing

machine with holding brackets.

Order the holding brackets (set)

from Bosch Customer Service

(WMZ 2200).

Advertising
This manual is related to the following products: