Univex Aquastop 800 series - Manual (Page 25)

25
Child lock
You can secure your washing machine
to prevent selected functions from
being changed inadvertently (see quick
overview of individual settings, page
24).
If Child lock has been selected:
-
No changes can be made while
the cycle is running.
- The door remains locked at the
end of the cycle.
Starting a cycle with Child
lock: on"
q Turn the cycle selector to the
desired cycle.
q Load the laundry and close the
door.
The
Start/Pause indicator light
flashes.
q Press the Start/Pause button and
hold down (5 seconds).
The cycle starts. The indicator light
is lit.
Child lock is activated.
To deactivate Child lock press the
Start/Pause button again (for 5
seconds) until the Start/Pause
indicator light flashes. Now you
can change cycles or options.
Press the Start/Pause button to
reactivateChild lock.
Pausing the cycle to
Add/Remove Laundry
q Press the Start/Pause button and
hold down (5 seconds). Child lock
is deactivated and the cycle will be
interrupted.
A running cycle with Child lock
activated can be stopped by
turning the cycle selector to Off".
The interrupted cycle will continue
when the machine is turned on
again.
Unloading laundry at the end
of a cycle with Child lock:
on"
q
Press the Start/Pause button and
hold down (5 seconds).
You can open the door and
remove laundry.
The Child lock setting remains
activated even if you switch off the
appliance.
Next time you switch on the
appliance Child lock is activated.
The door is locked and no
changes can be selected.
Press the Start/Pause button (for
5 seconds) to open the door.
Deactivating Child lock
q Turn the cycle selector to the
desired cycle to switch on the
appliance.
q Press the Menu button until Child
lock: on" is displayed.
The 
G " symbol flashes.
q Press the Select button until
Child lock: off" is displayed.
You can set Child lock on/off
before starting a cycle or in
Pause" mode only.
Special features
Auto Load adjust
Auto Load adjust" adjusts the water
and energy consumption for each cycle
and determines the amount of laundry.
This process is built into your machine
and occurs automatically.
The result is a reduction in water and
energy consumption when washing
small loads.
AVSt Anti-Vibration System
Unbalanced load detection
The AVSt automatic unbalanced load
detection system determines whether
or not the load is correctly balanced for
spinning. If the load is not evenly
distributed, the spin will be restarted. If
after a pre-determined number of
attempts the load cannot be balanced
the spin will be aborted and the cycle
resumed.
Displayed Time
When a cycle has been selected, the
expected cycle time is displayed.
The following will affect the displayed
time:
-
Load size
- Repeated spin attempts to evenly
distribute load
- Additional rinse cycles if excessive
foam occurs
- Low water pressure
- Selection of additional options,
e.g. Allergy Rinse"
Due to these and other characteristics
of the controls, the actual cycle time will
vary.
You may notice that these effects
(more or less time) change the
displayed time when they occur in
the cycle. If no options are
selected and these effects do not
occur, the time indicated will be
the time that the cycle will finish.