Univex Aquastop 800 series - Manual (Page 31)

31
Fault Possible cause Action
The laundry was not spun.
(Laundry is still wet).
Large items of clothing have become entangled and could
not be distributed evenly in the drum. For reasons of
safety the highćspeed spin cycle was automatically
prevented.
Always load the drum with several large and small items
together.
Excessive suds due to too much detergent, non-HE
detergent used Mix 1 tablespoon of fabric softener with 1 pint (1/2 liter) of
water and pour into the main detergent dispenser
chamber; reduce the amount of detergent used; use HE
detergent. (look for the HE" symbol).
Unsatisfactory washing
result .
The degree of soiling was higher than estimated. Select suitable cycle
or
Stain removal as an additional option.
Not enough detergent. Add detergent according to the manufacturer's
specifications.
Detergent residue on the
laundry.
Some phosphateĆfree detergents contain waterĆinsoluble
residues that may appear as light spots on the laundry.
Brush off spots when laundry is dry.
Gray residue on the
laundry.
Dirt accumulation from ointments, fats or oils. Add the maximum amount of detergent and select the
highest permissible temperature.
System shakes or shudders
when passing from lower to
higher speed spinning.
Drum system suspension can shift during speed up, this
is not a failure.
Mix small and large laundry pieces in load to minimize
this effect. Make sure the unit is level, see page 15.
Fault displays
Text in display
field
Possible cause Action
"Check water tap!" Water faucets not turned on. Turn on water faucet. cycle continues. "Check water tap!"
Supply hose kinked or trapped. Eliminate the cause.
Strainer in supply hose clogged. Clean the water inlet strainers (see Page 27).
Water pressure too low. Eliminate the cause.
Aquastop

Hose safety feature activated. Check for safety indicator (see page 13). If red, replace
hose.
"Suds or blocked
pump?"
Too much detergent used or pump is blocked. Use less detergent for future wash loads. Detergents
specifically designed for your High Efficientcy washer
produce fewer suds and will include the letters HE" on the
packaging.
Clean the water drainage pipe and/or drain hose.
"Check Door!" Door not closed properly. Check whether laundry is trapped in door.
Close the door.
AquaStop t
Activated"
AquaStop t is triggered Close water faucet and investigate the leak.
Locate and resolve the leak. Check all connections.
Contact Customer Service to reset AquaStop t
(refer to Page 32).
If the fault cannot be eliminated with the aid of the above table, switch the appliance off, wait 5 seconds, switch the appliance on
again, select and start the cycle.
If the fault continues, call customer service; see Page 32.