Univex Aquastop 800 series - Manual (Page 30)

30
Fault Possible cause Action
Cycle does not start. Real
Time delay" is indicated in
the display field.
End time selected and activated. None. Appliance starts automatically.
Clock cannot be set. Cycle has already started; when a cycle has started, the
clock cannot be set.
Wait until cycle ends.
"Set clock:" text remains in
the display field even
though the
Menu button
has been pressed.
The setting has switched from hours to minutes; both
selection points have the same text.
None.
No time displayed. Time not set. Set time (see Page 18).
End time cannot be
selected.
Time not set. Set time (see Page 18). End time cannot be
selected.
Cycle has already started; when a cycle has started, the
end time can no longer be selected.
Before starting the cycle, select and start the desired end
time (see Page 24).
Spin speed cannot be
selected.
Spinning is already in progress; during spin cycle the
speed cannot be changed.
Select speed before spinning.
Child lock cannot be
selected.
The cycle has already started. Child lock can be selected in pause mode.
Detergent residue in the
detergent dispenser.
Detergent was damp or lumpy. Clean and dry the detergent dispenser (see Page 27).
Use the cap of the detergent bottle to measure liquid
detergents.
Water does not enter the
machine or detergent is not
washed away.
"Check water faucet!"
Water faucet not turned on. Turn on water faucet.
Cycle continues.
"Check water faucet!"
indicated in the display
field.
Supply hose kinked or pinched. Eliminate the cause.
Strainers in supply hose clogged. Clean the water inlet strainers (see Page 27).
Aquastop

Hose safety feature activated. Check for safety indicator (see page 13). If red, replace
hose.
Aquastop

is triggered Close water faucet and investigate leak.
Water pressure too low. Eliminate the cause.
Water cannot be seen in
drum.
This is not a fault.
The water level is below the visible part of the drum.
Washing solution has not
drained completely. "Suds
or blocked pump?"
indicated in the display
field.
Suds Use less detergent for future wash loads. Detergents
specifically designed for your High Efficiency washer
produce fewer suds and will include the letters HE" on
the packaging.
Pump is blocked Clean the water drainage pipe and/or drain hose.
Water is flowing out from
underneath the machine.
The thread of the supply hose is not tight. Tighten the thread. Water is flowing out from
underneath the machine.
Leak in the drain hose. Replace the drain hose.
Suds coming out of the
detergent dispenser.
Too much soap or non-HE soap used, pump could not
remove suds.
Mix 1 tablespoon of fabric softener with 1 pt (½ litre) of
water and pour into the detergent compartment (do not do
this with outdoor (waterproof) fabric)
Use less detergent for future wash loads. Detergents
specifically designed for your High Efficiency washer
produce fewer suds and will include the letters HE" on
the packaging (look for the HE" symbol).
Repeated spinning. This is not a fault.
The unbalanced load detection system is attempting to
balance the load through repeated spins.
Always load the drum with several large and small items
together.
The laundry was not spun.
(Laundry is still wet).
Load size too small. Add more laundry.