VIPowER Portable External Enclosure VP-9258(T) - Manual (Page 17)

VP-9258(T) USER MANUAL 17
5-3 Mac OS 9.X or Above
1. This USB 2.0 External Drive is supported by Mass Storage
Support Mac OS 9.X or above. You do not need to install any
drivers.
2. When you plug this USB 2.0 Hard Disk into the USB port of your
Mac computer, the mass storage volume should automatically
appear on the desktop in a few seconds.
6. Using The USB 2.0 External Enclosure
After the first time installation, you can connect or disconnect the
USB 2.0 External Enclosure VP-9258 without powering off the
computer.
Please follow the steps below when using the VP-9258.
6-1 Connect the USB 2.0 External Enclosure VP-9258(T) to
Computer
Step1:
Plug the first USB port connector of the USB cable into the USB
port of your USB 2.0 External Enclosure VP-9258(T).
Step2:
Plug the second USB port connector of the USB cable into an
USB port on your computer.
Step3:
Plug the power adapter power cord to the power inlet of your
USB2.0 External Enclosure VP-9258(T). Turn the power of the
VP-9258(T) ON.
Step4:
On the Monitor screen, click on [Start] and select [Control Panel]
in [Settings]. Double click [System] and open [Hard disk controllers].