VBrick Systems VB5000 - Manual (Page 29)

MPEG-2 Configuration
VBrick MPEG-2 Appliance Admin Guide 21
Receive Enable Controls whether the decoder receives the video from the network.
Receive Address
Mode Allows the user to specify how the receive address will be
configured:
• IP Address – If the address entered in Receive IP Address (see
below) is 232/8, the decoder will issue a source-specific
multicast join if you enter the IPv4 address of the encoder in the
Source IP Address field.
• Host Name – This mode is only used for receiving unicast from
the encoder. The Source IP Address is not used.
• Program Name – Select from the list of MPEG-2 program
names being multicast on the network. The Source IP Address is
displayed but is read-only. The decoder will automatically update
the Source IP Address field with the source IP address of the
encoder generated by the program SAP.
Available Programs Use when Receive Address Mode is Program Name. Select from
dropdown list of available programs. This automatically populates
Receive IP Address and Source IP Address.
Receive Host Name Use when Receive Address Mode is Host Name. Sets the source for
video by using the Host Name. This parameter can be used only for
a unicast source.