VBrick Systems VB5000 - Manual (Page 77)

Status
VBrick MPEG-2 Appliance Admin Guide 69
Note The MPEG-2 encoder is designed to stream video indefinitely when it has a valid
video input and will stream black video for up to a few hours when the video input is
missing or invalid. However, if the video input has been invalid for more than a few
hours you should either reset the encoder or restart it by making an audio or video
configuration change.
Encoder State Running indicates normal operation. Video Input Problem
indicates a problem with the video source. Verify that the video
source is working correctly and that your video cable is good.
Verify that the Configuration: Encoder > Video > Video Input
Type is properly set to Composite or S-Video to match your
source connection. Verify that Configuration: Encoder > Video >
Video Format is properly set to NTSC or PAL to match your
source format. Note that the WM encoder will transmit black
video when there is an input problem.
Micro-Code Revision Displays the encoder micro-code revision.
FPGA Revision Displays the FPGA revision number.
PLX EEProm Revision Displays the EEProm revision number.
Transmit State Displays
Transmitting
or
Not Transmitting
.
IP Bytes Transferred Number of bytes sent across the network
Buffer Full Count Displays any full buffer counts that occur.
IP Packets Sent Displays the number of packets sent across the network.