Veo Observer - Manual (Page 12)

Page 12 of 65
3.2 Web Browser Access
1. From any PC on the local network, start Internet Explorer and enter the camera’s IP address in the address
bar, as shown below, then press Enter. For help on determining the camera IP address refer to Section 2.2:
Getting an IP address.
2. The first time you access the camera it will install an ActiveX control on your PC. You should see a dialog like
the one shown here. If you don’t, your Internet Explorer security settings may prohibit downloading signed
ActiveX controls. Please restore the default security settings. For help configuring your Internet Explorer security
settings, see Appendix E: Internet Explorer Security Settings.
3. The camera’s welcome page will appear as shown below. If the welcome page does not appear or Internet
Explorer shows an error page, refer to the troubleshooting section in Appendix G: Frequently Asked
Questions, Troubleshooting, and Technical Support.
Note: If the Observer
ActiveX control is not already
installed on your PC, you will
notice that it takes some
extra time for the page to
load. The Enter button won’t
appear until the page
finishes downloading.
4. Click Enter to log in to the camera.