Veo Observer - Manual (Page 50)

Page 50 of 65
5. To set the router for DHCP click on LAN IP Setup.
6. Select Use Router as DHCP server.
7. Enter a Starting IP Address and an Ending IP Address.
8. Click Apply.
9. On the Main menu in the Maintenance section click on Attached Devices. Write down the IP address
assigned to the camera.
10. Click OK.
Veo Observer as a Virtual Server
1. Click on Port Forwarding.
2. Click on Add Custom Service.
3. Enter a name for the camera under Service Name.
4. For the Starting Port enter 80.
5. For the Ending Port enter 80.
7. Enter the IP address assigned to the camera for
Server IP Address. Repeat the process for port 1600.
8. Click Apply at the bottom of the menu.